0013: Running at Creep - Tilted and Above Elevation

Normal characteristic, faulty tilt sensor, faulty elevation sensor

1. Determine the machine state first and check the tilt configuration within machine setup.

A. If the unit is tilted beyond the machine setup parameters and the boom is elevated this DTC and condition is normal and expected. Note: In some instances machine setup also has a tilt selection for CUT available, in these case the functions will be cut out when tilted and elevated beyond transport.

B. If the unit is tilted beyond the machine setup parameters but the boom is not elevated check for an issue with a transport position switch/sensor (see 0010 running at cutback out of transport) that may be triggering the control system to believe the unit is out of transport.

C. If the unit is not tilted beyond the machine setup parameters move the unit to a level area and use the analyzer to calibrate the tilt sensor.