2239 - Function Problem - Joystick Calibration FaultyRelated models
Fork tilt switch needs calibrated. Note: It is important Enter is pressed after each step of the calibration procedure. Symptoms2239 FORK TILT NOT CALIBRATED Possible CausesFaulty fork tilt switch Troubleshooting Steps1. Locate the JLG analyzer plug in port. The analyzer port is located below the key switch and plug in the JLG analyzer with the engine off and the key switch in the run position.
A. Then using the right arrow key to navigate to ACCESS LEVEL 2/33271/CALIBRATIONS/JOYSTICK FORK TILT and press enter to confirm that the fork tilt is going to be calibrated.
1. After each step in the calibration procedure, the enter button must be pushed to complete the calibration step.
a. If the analyzer shows the fork tilt calibration is complete, then the key switch will need to be cycled off and back on to verify the code is gone.
b. If the analyzer shows the fork tilt failed, then the cabin joystick will need replaced. Related DocumentsService Manual
|
